Thermo Scientific MaxQ SHKE8000 Series Operating And Maintenance Manual page 21

Test Tube Racks & Adj.
Angle Rack Holder
RS-232 Interface
Connector
Thermo Scientific
To remove the rack, spread the metal tabs on either end of the holder and
lift it out.
To install the Test Tube Rack
Holder onto the shaker platform,
remove the rack and rotate the
swing-bed of the holder 90° by
pulling the knobs of the locking
pins on either end of the holder
outward. The pins are locked in the
outward position by turning the
knobs 1/4-turn (Figure 1-26).
Attach the holder to the platform
with the screws provided.
These orbital shakers are equipped with an RS-232 Serial Communication
Interface for the remote transmission of data. An RJ-11 telephone style
connector is located on the lower front left corner of the cabinet, behind
the kick panel (Figure 1-27). A cable with RJ-11 plugs and an RJ-11 to
DB-25 adapter are required.
Figure 1-27. Location of RS-232 and Remote Alarm Connectors
Figure 1-26. Test Tube Rack Holder w/
Rack Removed and Bed Rotated 90°
MaxQ SHKE8000 Series Shakers
Section 1
Installation
1-13