Table of Contents
Advertisement
Section 1
Installation
Floor Installation of
Stacked Units (cont.)
Figure 1-6. Remove Four Screws (middle or top unit)
1-4
MaxQ SHKE8000 Series Shakers
1. For easier access to stacking connection points on the middle or top
units, the four screws on the front of the relay box bracket may be
removed (Figure 1-6). The relay box can be pushed carefully back
approximately an inch or pulled carefully outward to access the back
connection point. The stacking hardware can then be installed as
follows. When the stack has been secured, pull the relay box forward
and reinstall the four screws.
Connection point
2. Place the 1½ inch tall spacers (Figure 1-7) over the
threaded inserts in the top four corners of the base
unit (Figure 1-2).
3. Using the appropriate lifting device, carefully raise
the unit to be stacked. Remove all (4) leveling feet.
4. Carefully lift and position the middle or top unit over the spacers on
the base unit. Align the (4) connection point holes in the bottom of
the middle or top unit with the (4) spacers and threaded inserts.
(Helpful hint: use masking tape around outside edge of spacers to hold
in place during installation. Remove tape after installation.)
5. Assemble the lockwashers, then the
flatwashers, onto the 5/16-18 x 4" bolts.
Thread the bolts through the connection
point and spacer and into the unit below
(Figure 1-8). Tighten bolts.
6. Repeat Steps 2 through 5 for top unit if
required.
7. Reinstall all brackets and cover panel. Be
careful when routing wiring and wire
connectors on rear of relay box. This
may affect operation of the shaker.
Connection point
behind relay box
Connection point
Remove four
screws
Figure 1-7. Spacer
bottom left corner
of shaker
lockwasher
flatwasher
4 in. bolt
1-1/2" spacer
top left corner
of base unit
Figure 1-8. Shaker To Shaker
Thermo Scientific
1½
Advertisement
Table of Contents
