Brake System - Segway Villain SX10 Owner's Manual

The front and rear brakes are hydraulic disc type brakes that are activated by the brake
pedal.
• Brake fluid levels must be checked periodically.
• Overfilling of the brake cylinder may cause brake
resistance or brake locking, which may result in serious
• [this needs to be a bullet like the rest. I cannot change it
in workd] Keep the brake fluid at the recommended level
• Must check brake disc brake disc wear condition
The following inspection is recommended to keep the braking system in good
working condition. If the brake is in heavy use during normal operation, check it
frequently.
1. Always keep the brake fluid at an appropriate level. Please refer to master
cylinder/brake fluid section for details.
2. Check the braking system for any leakage.
3. Check whether the brake pedal stroke feels too long or feels soft.
4. Check whether the friction gasket is worn, damaged or loose. When replacing
the brake gasket, the brake pad must be replaced when the remaining limit
thickness of the brake pad is not less than 0.04 in (1mm).
5. Check the safety and surface condition of the disc. Use the recommended
brake cleaner or liquid to clean any grease. Do not use spray lubricants or
other petroleum-based products. If any damage (crack, excessive corrosion,
warping) is found, please check with your Segway dealer befor further
operation.
Brake Fluid
Use the recommended brake fluid:
Brake Fluid
The hydraulic auxiliary brake system does not require adjustment. Check the brake
fluid level of the auxiliary brake system frequently, and observe the brake fluid from
the brake fluid sight hole cover on the front left side. If the display shows that the
liquid level is low, perform the following operations.
1. Remove the front refill cap.

BRAKE SYSTEM

WARNING WARNING
!
injury or death.
and do not overfill.
regularly.
4-17
DOT4