Shock Abosrber; Shock Abosrber Preload Adjustment - Segway Villain SX10 Owner's Manual

SHOCK ABOSRBER

Shock abosrber preload adjustment

The spring adjusting nut of the air pressure damping shock absorber is at the
upper end of the spring. Use a crescent wrench to loosen the lock nut. Then turn
the adjusting nut to loosen.
Adjust the nut position according to the range of the table below to achieve the
required comfort
1 2
Locknut Adjusting Nut
Screw the locknut to the desired position, then unscrew the adjusting nut to adjust
the position of the nut.
Setting standard of spring preload position:
Item
Front shock absorber:
Air pressure adjustable damping
spring preload setting position
(From the bottom of the upper
mounting seat to the position of
the adjusting nut)
Rear shock absorber:
Air pressure adjustable damping
spring preload setting position
(From the bottom of the upper
mounting seat to the position of
the adjusting nut)
High-speed compression
damping adjustment (clockwise
adjustment)
Low speed compression
damping adjustment (clockwise
adjustment)
Restoration damping adjustment
(adjusted from clockwise)
Gas pressure
Gear Spring Environment
1
Soft Flexible
↑ ↑
2
3
4
↓ ↓
Hard Solid
5
3 A
Crescent wrench
Factory setting Available range
64" Narrow version
20～45mm(0.8～1.8in.)
35mm(1.4in.)
72" Wide version
65～95mm(2.6～3.74in.)
85mm(3.34in.)
64" Narrow version
120～150mm(4.73～5.9in.)
35 130mm(5.1in.)
72" Wide version
170～210mm(6.7～8.37in.)
170mm(6.7in.)
Third Level 1-9 Level
First circle 0-2.5 circle
First Level 1-14 Level
1Mpa
4-22
Load Terrain Speed
Light Flat Low
↑ ↑ ↑
↓ ↓ ↓
Heavy Bump High
Spring preload position