Segway Villain SX10 Owner's Manual page 73

1. Put the vehicle on the horizontal surface.
2. Start the engine. Let it heat up for two to three minutes at idle.
Hot oil can cause skin burns. Don't let hot oil touch the skin
3. Place a suitable container under the oil drain plug
4. Remove the oil drain plug
5. Place a suitable container under the oil drain plug
6. Remove the oil drain plug
7. Take out the oil filter strainer 5 and clean the oil filter. See P4-11 for details
8. Wait for the waste oil in drain position 1 and drain position 2 to drain completely
Torque
Replace Oil Filter/Oil Strainer
Change the oil filter and clean the oil strainer every time you
Bolt M12×1.25×65
WARNING
!
1
to collect the discharged waste oil
1
, remove the O-ring and wait for the waste oil to drain completely
3
3
and remove the O-ring
Oil Drain Plug: 16-20N.m(11.8-14.8ft·lb) Oil Drain Plug: 16-20N.m(11.8-14.8ft·lb)
IMPORTANT
change the oil
Change Oil Filter
• The oil filter is located inside the left
rear wheel of the vehicle. Please refer
to the fluid recommendation table
for capacity and plug torque. Always
change the filter at the same time as
the oil change.
1. Use a jack to lift the rear of the
vehicle to a certain height.
2. Remove the bolts under the left rear
shock absorber, and place the shock
absorber tilted back aside.
3. Unscrew the oil filter with a tool, and
pay attention to the direction of the
screw when unscrewing.
4. Install a new filter and manually
rotate it clockwise until the filter gasket
touches the sealing surface until it is
tightened.
5. Re-fix the lower installation point
of the left shock absorber with bolt
M12×1.25×65.
81~88 ft·lb（110~120
4-10
to collect the discharged waste oil
4
N.m）