Segway Villain SX10 Owner's Manual page 57

• Do not move the winch to assist in hauling heavy objects, it is easy to overload
the winch and cause damage to the rope.
• Pay attention to the dangerous area. Stay away from the danger area during
winch operation.The dangerous area is the area that contains the winch drum,
fairlead, rope, pulley block, hook and motor.
• When the winch is under load, do not approach or cross the rope.
• When using the winch to move the load, place the vehicles transmission
in neutral and apply the brake of the vehicle and place wedges under each
wheel. When the hoist is working, the vehicle engine should be operated to
charge the battery. Never use the winch with insufficient voltage.
• Never disconnect the power supply when there is a load on the winch.
• After the operation, release the load immediately and do not tighten the rope.
• Always stay away from ropes, hooks and winches when in operation or under
load.
• Check winches, ropes, hooks, and broken strands of worn rope regularly.
When handling the rope, please wear thick leather gloves. Do not let the rope
slip over your hands. Check the rope before use.
• Crushed, pinched, worn or kinked areas seriously reduce the carrying
capacity. A damaged rope should be replaced. It must be re-wound under a
load of about 100 pounds.
• The clutch should be disconnected first, and then the rope should be pulled
by the hook of the protective lever. Do not pull the rope directly through the
hook with your fingers.
• Maintain the specified tension so that the rope can be wound on the reel and
re-rolled after the operation tight.
• Do not operate the winch under the influence of alcohol or drugs. Be cautious
during operation. If there is a problem, you should cut off the battery
immediately and check it carefully.
• Wear goggles, insulating overalls, non-slip shoes, work caps, thick leather
gloves, Place long hair tightly under a work cap and remove all jewelry.
• When the winch is in use, be sure to start the vehicle engine and set the gear
position to "N."
• When the winch is working, it will draw voltage, so you must start the vehicle
and step on the accelerator lightly to avoid damage to the battery.
• If severe noise or vibration occurs during the use of the winch, it must be
3-14