High Beam Adjustment - Segway Villain SX10 Owner's Manual

High beam adjustment

The headlight beam can be adjusted slightly up/down. Use the following procedure
to make adjustments ot the headlight.
The following pictures are for reference only. Your model may
It is best for a Segway dealer to adjust if conditions permit.
1. Place the vehicle on a horizontal plane with a headlight position of about 32 ft
(10m).
2. Measure the distance from the floor to the center of the headlights and mark
the walls at the same height.
3. Start the engine. Adjust the headlight switch to high beam.
4. Watch the headlights aim at the wall. The strongest part of the headlight beam
should be 2 in (5cm) below the mark on the corner.
Adjust the headlight beam upwards and downwards
To raise the headlight beam, turn the headlight adjusting screw counterclockwise.
To lower the headlight beam, turn the headlight speed adjustment screw clockwise.
CAUTION
!
be slightly different.
1
Light adjusting screw
4-28