Add Engine Oil - Segway Villain SX10 Owner's Manual

Torque

Add Engine Oil

The engine oil filling port is located under the rear cargo bed. Remove the rear
cargo bed (see page 4-5)
7. Stop the engine.
8. Check for any leaks.
9. Check the oil level and add oil as needed to make the oil level reach the mark
on the dipstick.
10. Properly dispose any used filters and oil.
Oil Strainer Cleaning
1
Oil drain plug
2
O-ring
3
oil strainer
1. Remove the drain plug, take
off the O-ring, and remove the
oil strainer.
2. Clean the strainer and allow
to dry.
3. Install new O-rings and
reinsert the clean oil strainer.
Drain Plug: 16-20N.m(11.8-14.8ft·lb) Drain Plug: 16-20N.m(11.8-14.8ft·lb)
1. Unscrew the oil cap.
2. Add an appropriate amount
of the recommended oil type and
be careful to not overfill it. The
correct oil level is between the
upper scale and the lower scale
marks.
3. Replace the oil cap.
4. Put the gear shifter in
"Park."
5. Lock the parking brake.
6. Start the engine and let it
idle for 5 minutes.
4-11