Running The Gth Ibert Demonstration - Xilinx Virtex-7 FPGA VC7215 Getting Started Manual

Running the GTH IBERT Demonstration

The GTH IBERT demonstration operates one GTH Quad at a time. This section describes how
to test GTH Quad 115. The remaining GTH Quads are tested following a similar series of
steps.
Connecting the GTH Transceivers and Reference Clocks
Figure 1-1 shows the locations for all GTH transceiver Quads on the VC7215 board.
Figure 1-1
Note:
X-Ref Target - Figure 1-1
VC7215 Getting Started Guide
UG970 (Vivado Design Suite v2015.1) April 27, 2015
is for reference only and might not reflect the current revision of the board.
Figure 1-1: GTH Quad Locations
www.xilinx.com
Chapter 1: VC7215 IBERT Getting Started Guide
8
Send Feedback