Xilinx Virtex-7 FPGA VC7215 Getting Started Manual page 11

Attach the Samtec BullsEye connector to GTH Quad 115
indexing pins on the bottom of the connector with the guide holes on the board. Hold the
connector flush with the board and fasten it by tightening the two captive screws.
X-Ref Target - Figure 1-5
GTH Transceiver Clock Connections
Refer to Figure 1-2, page 9
CLK0 reference clock inputs. Connect these cables to the SuperClock-2 module as follows:
• CLK0_P coax cable → SMA connector J5 (CLKOUT1_P) on the SuperClock-2 module
• CLK0_N coax cable → SMA connector J6 (CLKOUT1_N) on the SuperClock-2 module
Any one of the five differential outputs from the SuperClock-2 module can be used to source
Note:
the GTH reference clock. CLKOUT1_P and CLKOUT1_N are used here as an example.
VC7215 Getting Started Guide
UG970 (Vivado Design Suite v2015.1) April 27, 2015
Figure 1-5: BullsEye Connector Attached to Quad 115
to identify the P and N coax cables that are connected to the
www.xilinx.com
Chapter 1: VC7215 IBERT Getting Started Guide
(Figure 1-5), aligning the two
11
Send Feedback