Running The Gth Ibert Demonstration - Xilinx Kintex UltraScale FPGA KCU1250 Getting Started Manual

Running the GTH IBERT Demonstration

The GTH IBERT demonstration operates one GTH Quad at a time. This section describes how
to test GTH Quad 224. The remaining GTH Quads can be tested by following a similar series
of steps.
Connecting the GTH Transceivers and Reference Clocks
Figure 1-1 shows the locations for GTH transceiver Quads 224, 225, 226, 227, and 228 on
the KCU1250 board.
Figure 1-1
Note:
Quad 131 and Quad 132 are not available on the XCKU040 device.
Note:
X-Ref Target - Figure 1-1
QUAD_224 QUAD_225 QUAD_226 QUAD_227 QUAD_228
KCU1250 IBERT Getting Started Guide
UG1061 (v2017.4) December 20, 2017
is for reference only and might not reflect the current revision of the board.
QUAD_131
Figure 1-1: GTH Quad Locations
www.xilinx.com
Chapter 1: KCU1250 IBERT Getting Started Guide
QUAD_132
7
Send Feedback