Closing The Ibert Demonstration - Xilinx KC724 IBERT Getting Started Manual

Chapter 1: KC724 IBERT Getting Started Guide
X-Ref Target - Figure 1-17
Figure 1-17: Click TX Reset then BERT Reset If MGT Link Status = No Link

Closing the IBERT Demonstration

To stop the IBERT demonstration:
1.
2.
Additional information on the ChipScope Pro software and IBERT core can be found in:
•
•
18
Close the ChipScope application by selecting File → Exit.
Note:
Do not save changes to the project.
Place the main power switch SW1 in the off position.
UG029, ChipScope Pro Software Cores.
DS855, ChipScope Integrated Bit Error Ratio Test (IBERT) for Kintex-7 GTX (v2.00.a)
www.xilinx.com
ug930_c1_17_101512
KC724 IBERT Getting Started Guide
UG930 (v1.0) October 23, 2012