Running The Simulation - Xilinx Spartan-6 User Manual

Chapter 1: Spartan-6 FPGA GTP Transceiver Signal Integrity Simulation Kit
•
•

Running the Simulation

Click the Start Simulation button and wait for the simulator to finish the simulation. The
waveform window automatically displays the results for the selected waveforms in the
oscilloscope. The vertical and horizontal scales can be adjusted to maximize the
waveforms, as shown in
X-Ref Target - Figure 1-8
16
The radio buttons in the IC modeling group
simulation corner selections are made using the Configure Model button in the
Assign Models dialog box.
Checkboxes with the red SPICE label on their left
symbol nodes that are connected to NC in the Assign Models dialog box. These
nodes are defined on the subcircuit definition line of the symbol. They do not need to
be connected to anything else on the schematics because they are used solely to
provide probing capabilities for waveforms inside the subcircuits.
Figure
Figure 1-8: Example Simulation Results
www.xilinx.com
(Figure 1-6) are ineffective because the
(Figure
1-8.
Spartan-6 FPGA GTP Transceiver SIS Kit (HyperLynx)
1-6) represent schematic
UG396_c1_08_042010
UG396 (v1.0) June 10, 2010