Ingenico iCT220 User Manual
Counter top
Hide thumbs
Also See for iCT220:
- User manual (88 pages) ,
- Technical manual (36 pages) ,
- Quick start manual (27 pages)
Related Manuals for Ingenico iCT220
Summary of Contents for Ingenico iCT220
- Page 1 Product name iCT220/iCT250 Range : COUNTER TOP INGENICO – 28-32 Boulevard de Grenelle –75015 Paris - FRANCE Tél. 33(0)1 58 01 80 00 - Fax 33 (0)1 58 01 91 35 www.ingenico.com...
-
Page 2: Table Of Contents
3.6. Main Characteristics ___________________________________________________8 4. Installation and connection _____________________________________ 9 4.1. Positioning the terminal ________________________________________________9 4.2. Connections__________________________________________________________9 4.3. Installing the iCT220/iCT250 – Cable fixing__________________________________9 4.3.1. Opening the cable cover_________________________________________________________ 9 4.3.2. Kit Magic Box installation _______________________________________________________ 10 4.3.3. Connect cables ________________________________________________________________ 11 4.3.4. -
Page 3: Introduction
Failure to comply with these instructions will void the manufacturer’s responsibility. Unpacking ADVICE Carefully preserve the packaging of the iCT220/iCT250. It must be re-used whenever the terminal is shipped. According to the model, the following items are included in the iCT220/iCT250 box •... -
Page 4: Recommendations
Lithium battery The iCT220/iCT250 is fitted with a lithium battery which is not accessible to the user. Only a qualified technician may be authorized to open the unit and change this component. Electrical power supply network... -
Page 5: Security Of Your Terminal
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. • Product name : iCT220/iCT250 5/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012... -
Page 6: Fcc Compliance
: o IEC 60950-1 2 Ed: Electrical safety of data processing equipment including electrical office equipment o FCC part 15 C (ICT250 ), FCC part 15 B(ICT220 ) o FCC part 68 o EN 55024 3.5. - Page 7 United States Tel: +1(678) 456 1200 Fax: +1 (678) 456 1201 Email: info.us@ingenico.com CAUTION The user is cautioned that any changes or modification not approved by INGENICO could void user’s authority to operate the equipment. • Product name : iCT220/iCT250 7/21 Copyright ©...
-
Page 8: Main Characteristics
Class II equipment Input voltage 100-240VCA-50-60 Hz Max consumption 800 mA Cable length Power block cable approx 1,8 m Telephone cable approx 3 m • Product name : iCT220/iCT250 8/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012 All rights reserved... -
Page 9: Installation And Connection
USB Host Power Supply Second Serial Link RS232 according to the model (Optional)* 4.3. Installing the iCT220/iCT250 – Cable fixing 4.3.1. Opening the cable cover • Unclip the cover by pushing simultaneously on the clips with your nails finger as shown on the figure here below. -
Page 10: Kit Magic Box Installation
Install caps in the lead-through (as indicated on the figure). • Close the compartment with the special cover provided in the kit, like the procedure described at chapter 4.3.4. • Product name : iCT220/iCT250 10/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012 All rights reserved... -
Page 11: Connect Cables
Plug the power leads (5) into the power outlet (6), connect the other end into the power connection (7) of the magic box. Plug: TNV-3 circuit: Telecommunication Network Voltage, as per safety standard EN 60950. • Product name : iCT220/iCT250 11/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012... -
Page 12: Close Cover
The “Magic Cable” should be readily accessible for support and terminal helpdesk diagnosis purposes. Note: The connection Magic Box can also be attached using a VELCRO™ or other system. • Product name : iCT220/iCT250 12/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012... -
Page 13: Installing Sam (Secure Access Module)
Adhesive CAUTION: Do not use any tools when installing or removing the SAM Card. Replace the cover as illustrated by the procedure below: • Product name : iCT220/iCT250 13/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012 All rights reserved... -
Page 14: Installing Microsd Card (Optional)
The insertion position Card is engraved on the terminal. • To remove the MicroSD Card push on it with your finger nails. • Product name : iCT220/iCT250 14/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012 All rights reserved... -
Page 15: Installing A Paper Roll
(see characteristics at the chapter 7.1). • Open the paper compartment by lifting the catch located at the rear of the iCT220/iCT250 and pulls the cover to the rear of the terminal. LIFT ATTENTION Do not force the cover against the cables. -
Page 16: Daily Use
(dot key) and key in order to increase. Keep pressing the keys as long as necessary. • Product name : iCT220/iCT250 16/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012 All rights reserved... -
Page 17: Card Insertion
The card read is successful when all four status lights are lit and the confirmation tone is heard. Contact’less Active Zone • Product name : iCT220/iCT250 17/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012 All rights reserved... -
Page 18: Maintenance
CAUTION In order to benefit from the complete guarantee of the product, only heat sensitized paper approved by the manufacturer can be used. • Product name : iCT220/iCT250 18/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012 All rights reserved... -
Page 19: Cleaning Of The Terminal
Possibly adjust the paper roll following instructions present in this manual • Check the type of paper used (thermal paper must be used) • Product name : iCT220/iCT250 19/21 Copyright © 2012 Ingenico 900002734 R11 000 05/4012 All rights reserved... -
Page 20: End Of Life
To assure that the product is collected and recycled with respect to the environment, you must contact your supplier (in defect, contact the Ingenico local office or the commercial head office in charge of your country on www.ingenico.com, « contact us » page). - Page 21 INGENICO. Moreover, nobody is authorized to place this document at the disposal of any third party without the prior written permission of INGENICO. If such permission is granted, it will be subject to the condition that the recipient ensures that any other recipient of this document, or information contained therein, is held responsible to INGENICO for the confidentiality of that information.