Installing Paper Roll - Ingenico IWL2G User Manual

4.4.2.

Installing paper roll

•
Open the paper compartment by lifting the catch located at the rear of the iWL2XX and
pull the cover to the rear of the terminal.
•
Insert the paper roll in the compartment following the directions shown on the below
picture
•
Pull the paper up to the top of the terminal
•
Maintain the paper and close the cover
•
Press simultaneously on both upper corners of the paper flap, as shown by red arrows
on picture, until it clips into position
ADVICE
If you insert a new R40 paper roll, tear off the first length (one complete turn to avoid
printing on adhesive tape footprint). This is not necessary on R25 paper roll as it has no
tape.
•
iWL2xx Wireless Series
900003061 R11 000 04/1050
14/31
Copyright © 2011 Ingenico
All rights reserved