series Robot Controller
1.4.4
Assigning a Name to Load Data
When entering load data, you have to assign a load name to that data. A load in
the program is specified by the load name.
Generally, the load name has the following format.
SAMPLE1
The following characters can be used for the coordinate name. The first letter of a
load name must be an alphabetical character.
Alphabetic characters
Numerals
Cautions: • You cannot use an identifier (reserved word) used for the SCOL
language to name a point. For details, see Appendix B of the Robot
Language Manual.
• The load name entered should consist of up ten (10) characters. If it
exceeds this limit, the entry is invalid with an error saying "illegal name"
displayed.
• If a character other than the alphabetical characters has been entered
for the first character of the load name, the entry is invalid with an error
saying "illegal name" displayed.
Load name (1 ~ 10 characters)
:
A ~ Z
:
0 ~ 9
– 1-18 –
OPERATOR'S MANUAL
STE 80730