Test Operation - Toshiba TS3000 Series Instruction Manual

series Robot Controller
Section 6

Test Operation

NEVER enter the dangerous area of the robot during automatic operation. If you
still have to enter the dangerous area, be sure to terminate the automatic operation
and turn the servo power off beforehand.
1. Make sure that no obstacle stands in the robot working range. If any obstacle
exists, perform automatic operation at a slow speed and make sure that the
robot will not collide with the obstacle at all.
2. If the robot motion becomes abnormal during program execution, press the
EMERGENCY stop pushbutton switch immediately to stop the robot. NEVER
restart the automatic operation until the cause of the abnormality is identified.
3. The speed of automatic operation is initially set at 100% of the maximum robot
speed.
4. When performing automatic operation after power ON, reset the program for
the automatic operation in advance. If the program is executed continuously,
the robot will collide with the peripheral equipment, resulting in damage of the
equipment and an accident.
!
DANGER
!
CAUTION
– 6-1 –
OPERATOR'S MANUAL
STE 80730