External Input/Output Signal Display [I/O] - Toshiba TS3000 Series Instruction Manual

series Robot Controller

10.3 External Input/Output Signal Display [I/O]

(1) Function
Displays the status of external input/output signals.
(2) Procedures
(a) Step 1: Selection of file mode.
Press the NEXT key repeatedly until [I/O] is displayed in the menu. Press
the corresponding function key, and the following hand input/output signal
status display appears.
I / O M o n i
D I N 0 *
2 *
4 *
6 *
For the display contents, see Para. 2 below.
Keys operative in this mode and their operations are shown below.
Key




t o r ( S t a n d a r d
1
0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0
0 0 0 0
D I N
Used to move the cursor to the left. When the cursor is
located on the left end, it will not move at all.
This key is effective when the [ON] menu or [OFF] menu is
displayed.
Used to move the cursor to the right. When the cursor is
located on the right end, it will not move at all.
This key is effective when the [ON] menu or [OFF] menu is
displayed.
Used to move the cursor up. When the cursor is located at
the top, it will not move at all.
This key is effective when the [ON] menu or [OFF] menu is
displayed.
Used to move the cursor down. When the cursor is located
at the bottom, it will not move at all.
This key is effective when the [ON] menu or [OFF] menu is
displayed.
– 10-6 –
OPERATOR'S MANUAL
I N )
1 0 1 1
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
D O U T
Descriptions
1 / 5
2 0
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
S Y S
STE 80730