Henny Penny Velocity Series Operation Manual page 93

Program Display
Code
FC-29 START-UP MIX: FILL: NO DE-
TECT: MAX PUMP
FC-30 START-UP ATO CHECK:
ENABLED?
FC-31 START-UP ATO CHECK: PRE-
HEAT MAX TEMP
Phase 4 of the morning startup procedure is to execute the Start-up Auto Polish: drop the oil
into the drain pan, filter it for a long time, and pump it back into the pot. This feature is impor-
tant in cleaning the oil and restoring clarity to it.
pan in order for the Polish operation to be most effective.
FC-32 START-UP POLISH:
ENABLED?
FC-33 START-UP POLISH: PRE-
HEAT MAX TEMP
Description
3 3 . . Press "X" to return to default or previous
setting.
If the fryer pumps for this amount of time dur-
ing the FILL phase without observing a tem-
perature rise on the upper temperature
probe, the control turns the pump off, and
asks IS POT FILLED?. If pot is not filled com-
pletely, press NO and the pump will attempt
to fill further.
1 1 . . Enter a new value by using the product
numbers.
2 2 . . Press "" to accept the new value.
3 3 . . Press "X" to return to default or previous
setting.
Specifies whether or not the ATO (Auto Top
Off) Check, the third step of the Start-up
Mode, is enabled.
Press the + or - button to select either YES
or NO.
The Start-up Auto Polish procedure consists
of two steps: 1. Heat up to the Polish Preheat
temperature. 2. Drop the oil, filter (for a long
time), and refill the pot.
Filter powder should be added to the drain
Henny Penny recommends enabling the
Start-up Polish to prolong the life of the oil.
This adds time to the Start-up process.
Press the + or - button to select either YES
or NO.
The Start-up Auto Polish procedure consists
of two steps: 1. Heat up the Polish Preheat
83