Henny Penny Velocity Series Operation Manual page 103

Error Cause
E-47 ANA- Problem reading the
LOG SYS- A-to-D Analog to Di-
TEM OR gital converter
12 VOLT inputs.
FAILED
Failure of the CPU
E-48 IN-
PUT SYS- board.
TEM
ERROR
E-54C Fault on the CPU
MAIN board.
TEMP CIR-
CUIT
FAILURE
E-54D Fault on the CPU
MAIN board.
TEMP
DSC
ERROR
E-70A FAN Jumper wire is loose
JUMP or missing from 15
MISSING pin connector.
E-70B Short in wires/ loose
PWR connection.
SWITCH
Power switch may
OR WIRES
be faulty.
FAILED"
E-70C Loose connection on
DRN JUM- the 15 pin
PER connector.
MISSING
E-82 SE- The selector valve
LECTOR failed calibration or
VALVE not responding.
FAILURE
E-84C Pressure pin did not
PRES- fully engage.
SURE PIN
Correction
Call for service.
Call for service.
Call for service.
Call for service.
Call for service.
Call for service.
Call for service.
Call for service.
Call for service.
Call for service.
93