Henny Penny Velocity Series Operation Manual page 42

5 5 . . 4 4 P P r r o o d d u u c c t t R R a a c c k k i i n n g g R R e e c c o o m m m m e e n n d d a a t t i i o o n n s s
NOTICE :
T T R R A A I I N N I I N N G G :
T T R R A A I I N N I I N N G G :
T T R R A A I I N N I I N N G G :
The bottom position is to be avoided on small loads because it is closer to the cold
zone. The oil is cooler at the bottom of the vat and hotter at the top. With bigger loads,
however, there is generally enough turbulence in the oil that the bottom rack gets
sufficient heat. The top position is to be avoided on small loads because of insufficient
oil coverage. With bigger loads, the top rack has good oil coverage because the
volume of product on the lower racks raises the overall oil level.
32
1 1 . . Gently raise the lid handle until it stops.
2 2 . . Push the lid handle back until it stops.
3 3 . . Lower the lid handle.
4 4 . . Push the lid handle back.
5 5 . . Unlatch the front lid latch and raise the
Do not use any abrasive cloth, degreaser, oven cleaner, or any
type of corrosive cleanser when cleaning the coated parts. Hot
soapy water is all that is needed to clean these parts. Any of
the other cleaners mentioned above will greatly reduce the life
of the coating.
Watch a short video on how to Season the Racks.
Load racks from the bottom up and remove from the top down.
Do NOT slam the lid down.
lid.