Henny Penny Velocity Series Operation Manual page 101

Error Cause
E-6A MAIN Temperature probe
TEMP failure.
PROBE
FAILED
(Open
Circuit)
E-6B MAIN
TEMP
PROBE
FAILED
(Shorted)
E-10 (A High limit tripped.
thru Y)
E-13A Pressure transducer
PRES- failed or unplugged
SURE
SENSOR
FAILED
E-13B Pressure transducer
PRES- failed or shprted
SURE
SENSOR
FAILED
E-14 Pressure is to high
PRES- within the vat.
SURE
TOO HIGH
E-15C The drain valve
DRAIN doesn't fully closed.
VALVE
ERROR
E-15P The drain valve
DRAIN doesn't fully open.
Correction
Turn the switch to off position, then turn the switch
back to on. If the error persists call for service.
Reset the high limit trip. The reset momentary switch is
below the control panel heat vents, under the lip, above
the condensation tank (box). Perform a clean out, refer
to 6.10 Clean-Out Mode , page
call for service.
T T R R A A I I N N I I N N G G : E-10 Error explanation.
Call for service.
Call for service.
Perform the 6.7 Cleaning Deadweight - Monthly , page
43 procedure. If the error persists call for service.
Unclog the drain with a drain brush. If the error persists
call for service.
Check drain for an obstruction. If the error persists call
for service.
55. If the error persists
91