Henny Penny Velocity Series Operation Manual page 50

6 6 . . 3 3 . . 4 4 C C l l e e a a n n t t h h e e F F r r e e s s h h O O i i l l T T a a n n k k ( ( A A T T O O ) )
NOTICE
:
N N O O T T E E :
The fresh oil tank (box) is a storage tank of fresh oil for the Automatic Top Off (ATO)
system. Daily pull the tank out half-way, lift the lid, and then top off with fresh oil. As
necessary, pull the tank out, clean, and then refill with fresh oil. While the daily filtering
process is cycling do the following:
Pull out the fresh oil tank halfway and open the lid. Refer to
1 1 ) )
Tank , page 13
Pull the tank out half way and then lift up, continue pulling out the tank.
2 2 ) )
Empty the oil in to a bulk oil disposal container.
3 3 ) )
Clean the tank with warm soapy water, and then rinse thoroughly.
4 4 ) )
Dry thoroughly, and then install the tank back in to the unit.
5 5 ) )
Add fresh oil to the tank as required.
6 6 ) )
Close the lid and carefully push the fresh oil tank back in to place.
7 7 ) )
40
To empty the condensation pan, do the
following:
1 1 . . Slide the condensation pan completely
2 2 . . Empty the water in to a sink with an oil
3 3 . . Clean the tank with warm soapy water,
4 4 . . Slide the condensation pan back in to
• Inspect the fresh oil tank o-rings and replace if damaged or
every 90 days.
• Use a small screw driver to gently pry o-rings from their
groove to inspect for damage. Reinstall by gently rolling
them in to place.
• Watch a short video explaining how to lubricate the o-rings
after installation.
Not used in bulk fill applications.
and Chapter 3 Operation , page
out of the appliance.
trap.
and then rinse and dry thoroughly.
the appliance. Ensure the lid is up
and the weep hole is positioned in
the upper, right corner.
2.9 Fill the Fresh Oil
15.