Henny Penny Velocity Series Operation Manual page 68

Use a scrub brush/pad on the vat walls to loosen any crumbs or debris.
3 3 ) )
Carefully clean the elements with a thin scrub brush.
4 4 ) )
Scrub the underside of the lid.
5 5 ) )
Remove and clean the lid gasket.
6 6 ) )
When completely scrubbed clean, press the D D O O N N E E √ √ button. DONE
7 7 ) )
SOAKING?, YES and NO displays.
Press Y Y E E S S , and then press the n n e e x x t t ► ► button.
8 8 ) )
Proceed to
9 9 ) )
6 6 . . 1 1 0 0 . . 6 6 P P e e r r f f o o r r m m t t h h e e H H e e a a t t e e d d C C l l e e a a n n - - O O u u t t
NOTICE
:
This procedure requires immediate cleaning without soaking overnight.
If necessary, press the O O N N button to power on the unit. =CLEAN OUT=
1 1 ) )
HEATING 78F x! displays.
WAIT. The temperature rises to 194 degrees, and then a 15:00 minute timer
2 2 ) )
starts with a beeper sounding. =CLEAN OUT= cleaning displays.
Use a scrub brush/pad on the vat walls to loosen any crumbs or debris.
3 3 ) )
Carefully clean the elements with a thin scrub brush.
4 4 ) )
Scrub the underside of the lid.
5 5 ) )
Remove and clean the lid gasket. The time on the timer runs out. =CLEAN
6 6 ) )
OUT= *DONE*, and then TURN FRYER OFF displays.
Press the power off button. =DRAIN= DRAIN (hold) and next► displays.
7 7 ) )
Proceed to
8 8 ) )
6 6 . . 1 1 0 0 . . 7 7 D D r r a a i i n n t t h h e e W W a a t t e e r r
A bucket, tub or the drain pan needs to be in place under the drain before proceeding
to draining. If using the drain pan, remove all the internal parts so the pan is empty. Do
not put the lid on the pan it must remain open for this procedure.
Press and hold the ▼ ▼ D D R R A A I I N N ( ( h h o o l l d d ) ) button. Draining water, and then drain small
1 1 ) )
amount to pan and then dump displays. The water drains in to the bucket/tub/
pan.
When the bucket/tub/pan is partially full, release the button and the water stops
2 2 ) )
draining.
Remove the bucket/tub/pan from under the fryer and dispose.
3 3 ) )
Repeat steps 3 and 4 in this section until the vat is completely drained.
4 4 ) )
Press the n n e e x x t t ► ► button. IS POT EMPTY? displays.
5 5 ) )
Confirm all the water is drained from the vat, and then press √ √ Y Y E E S S .
6 6 ) )
58
6.10.7 Drain the Water , page
Do not use a metal scraper or any type of abrasives to clean
the heating elements.
6.10.7 Drain the Water , page
58.
58.