Henny Penny Velocity Series Operation Manual page 66

NOTICE
:
T T R R A A I I N N I I N N G G :
After the initial installation of the fryer and during every oil change, the vat must be
thoroughly cleaned. There are two ways to clean the vat using the clean-out mode,
heated and cold soak. Operators can fill the vat with warm water and cleaning
solution, enable heat, and then scrub the vat immediately (P.M.) or let it soak
overnight cold and scrub it in the morning (A.M.). Cleaning the vat immediately is
called a Heated Clean-Out and allowing the vat to soak overnight is called a Cold-
Soak Clean-Out. The choice of which type of clean-out an operator uses is set during
installation within the software settings. Refer to Drain and dispose of the oil before
performing these procedures. Refer to
6 6 . . 1 1 0 0 . . 1 1 S S e e t t t t i i n n g g t t h h e e C C l l e e a a n n - - O O u u t t M M o o d d e e T T y y p p e e
Operators can choose between a Heated and a Cold-Soak clean-out. To select a
clean-out mode refer to
6 6 . . 1 1 0 0 . . 2 2 C C l l e e a a n n - - O O u u t t M M e e n n u u O O v v e e r r v v i i e e w w
Select the 1. FILTER menu, and then press the Main menu button twice to select 8.
CLEAN-OUT and perform clean out tasks.
56
• Do not use steel wool, or other abrasive cleaners or
cleaners/sanitizer containing chlorine, bromine, iodine or
ammonia chemicals, as these deteriorate the stainless steel
material and shorten the life of the unit.
• Do not use a water jet (pressure sprayer) to clean the unit, or
component damage may result.
• Do not bang brushes or scrapers on the pot band. Damage
to the pot band may cause gaps around the gasket
disallowing pressure to build when sealed.
• Make sure the inside of the vat, the drain valve opening, and
all parts that come in contact with the new oil are as dry as
possible.
• Do not use any abrasive cloth, degreaser, oven cleaner, or
any type of corrosive cleanser when cleaning the coated
parts. Hot soapy water is all that is needed to clean these
parts. Any of the other cleaners mentioned above will greatly
reduce the life of the coating.
Watch a language neutral video explaining the General Market
Clean Out Procedure.
6.9 Oil Disposal , page 47
7.5 Special Programming , page
for instructions.
69, SP-22 through SP-24.