Flooding Disable - H3C CR16000-F Command Reference Manual

Predefined user roles
network-admin
Parameters
s-vid vlan-id : Matches frames that are tagged with the specified outer 802.1Q VLAN ID. The
value range for the vlan-id argument is 1 to 4094.
Usage guidelines
To change the match criterion, first execute the undo encapsulation command to remove the
original criterion. When you remove the match criterion in an Ethernet service instance, the mapping
between the service instance and the VSI is removed automatically.
For more information about outer and inner 802.1Q VLAN IDs, see QinQ in Layer 2—LAN Switching
Configuration Guide.
Examples
# Configure Ethernet service instance 1 on GigabitEthernet 3/1/1. The service instance matches
frames that have an outer 802.1Q VLAN ID of 111.
<Sysname> system-view
[Sysname] interface gigabitethernet 3/1/1
[Sysname-GigabitEthernet3/1/1] service-instance 1
[Sysname-GigabitEthernet3/1/1-srv1] encapsulation s-vid 111
Related commands
display l2vpn service-instance

flooding disable

Use flooding disable to disable flooding for a VSI.
Use undo flooding disable to enable flooding for a VSI.
Syntax
flooding disable all
undo flooding disable
Default
Flooding is enabled for a VSI.
Views
VSI view
Predefined user roles
network-admin
Parameters
all : Specifies broadcast, unknown unicast, and unknown multicast traffic.
Usage guidelines
By default, the device floods broadcast, unknown unicast, and unknown multicast frames received
from the local site to the following interfaces in the frame's VXLAN:
•
All site-facing interfaces except for the incoming interface.
•
All VXLAN tunnel interfaces.
16