Xconnect Vsi - H3C CR16000-F Command Reference Manual

Use undo vxlan udp-port to restore the default.
Syntax
vxlan udp-port port-number
undo vxlan udp-port
Default
The destination UDP port number is 4789 for VXLAN packets.
Views
System view
Predefined user roles
network-admin
Parameters
port-number : Specifies a UDP port number in the range of 1 to 65535. As a best practice, specify
a port number in the range of 1024 to 65535 to avoid conflict with well-known ports.
Usage guidelines
You must configure the same destination UDP port number on all VTEPs in a VXLAN.
Examples
# Set the destination UDP port number to 6666 for VXLAN packets.
<Sysname> system-view
[Sysname] vxlan udp-port 6666

xconnect vsi

Use xconnect vsi to map an AC to a VSI.
Use undo xconnect vsi to restore the default.
Syntax
xconnect vsi vsi-name [ access-mode { ethernet | vlan } ] [ track
track-entry-number&<1-3> ]
undo xconnect vsi
Default
An AC is not mapped to any VSI.
Views
Ethernet service instance view
Interface view
Predefined user roles
network-admin
Parameters
vsi-name : Specifies the VSI name, a case-sensitive string of 1 to 31 characters.
access-mode : Specifies an access mode. The default access mode is QinQ mode, which is
supported only by Layer 3 subinterfaces.
ethernet : Specifies the Ethernet access mode.
33