Selective-Flooding Mac-Address; Service-Instance - H3C CR16000-F Command Reference Manual

Related commands
tunnel statistics enable

selective-flooding mac-address

Use selective-flooding mac-address to enable selective flood for a MAC address.
Use undo selective-flooding mac-address to disable selective flood for a MAC address.
Syntax
selective-flooding mac-address mac-address
undo selective-flooding mac-address mac-address
Default
Selective flood is disabled for all MAC addresses.
Views
VSI view
Predefined user roles
network-admin
Parameters
mac-address : Specifies a MAC address. The MAC address cannot be all Fs, all zeros, or a
multicast MAC address.
Usage guidelines
This command excludes a remote MAC address from the flood suppression done by using the
flooding disable command. The VTEP will flood the frames destined for the specified MAC
address to remote sites when unknown-unicast floods are confined to the local site.
Examples
# Enable selective flood for 000f-e201-0101 on VSI vsi1.
<Sysname> system-view
[Sysname] vsi vsi1
[Sysname-vsi-vsi1] selective-flooding mac-address 000f-e201-0101
Related commands
flooding disable

service-instance

Use service-instance to create an Ethernet service instance and enter its view, or enter the
view of an existing Ethernet service instance.
Use undo service-instance to delete an Ethernet service instance.
Syntax
service-instance instance-id
undo service-instance instance-id
Default
No Ethernet service instances exist.
23