Vtep Group Member Remote - H3C CR16000-F Command Reference Manual

Default
A VTEP is not assigned to any VTEP group.
Views
System view
Predefined user roles
network-admin
Parameters
group-ip : Specifies a VTEP group by its group IP address. The IP address must already exist on
the local VTEP.
member-ip : Specifies the member VTEP IP address for the local VTEP. The IP address must
already exist on the local VTEP.
Usage guidelines
Member VTEPs in a VTEP group cannot use the group IP address or share an IP address.
Examples
# Assign the local VTEP to VTEP group 1.1.1.1, and specify 2.2.2.2 as the member VTEP IP address
of the local VTEP.
<Sysname> system-view
[Sysname] vtep group 1.1.1.1 member local 2.2.2.2
Related commands

vtep group member remote

vtep group member remote
Use vtep group member remote to specify a VTEP group and its member VTEPs.
Use undo vtep group member remote to remove a VTEP group and its member VTEPs.
Syntax
vtep group group-ip member remote member-ip&<1-8>
undo vtep group group-ip member remote
Default
No VTEP group is specified.
Views
System view
Predefined user roles
network-admin
Parameters
group-ip : Specifies a VTEP group by its group IP address.
member-ip&<1-8> : Specifies a space-separated list of up to eight member VTEP IP addresses.
Examples
# Specify VTEP group 1.1.1.1 and its member VTEPs at 2.2.2.2, 3.3.3.3, and 4.4.4.4.
<Sysname> system-view
[Sysname] vtep group 1.1.1.1 member remote 2.2.2.2 3.3.3.3 4.4.4.4
47