Removing And Installing Rear Wheel Speed Sensor - Audi A6 2005 Workshop Manual

5.4 Removing and installing rear wheel
speed sensor
Removing
– Raise vehicle.
– Detach speed sensor wiring connector -1- from speed sensor.
– Remove bolt -2- from wheel bearing housing.
– Pull ABS speed sensor out of wheel bearing housing.
Installing
– Before inserting speed sensor, clean inner surface of fitting
hole and coat speed sensor thoroughly with grease - G 000
650- .
– Insert speed sensor into drilling in wheel bearing housing and
tighten bolt to 18 Nm.
– Connect speed sensor to speed sensor wiring.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
5. Removing and installing parts of ABS system on front and rear axles
49