Detaching And Attaching Front Brake Disc (Ceramic Brakes) - Audi A6 2005 Workshop Manual

Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
Note
The pad retaining spring must be under tension. The pad retaining
spring -17- must be seated underneath the pad retaining pin
-16- and above the pin for the pad retaining spring -15-.
– Lock each retaining pin with a clip -14-.
– Connect pad wear indicator wire.
– Clip in pad wear indicator wire.
– Fit wheels ⇒ ELSA/ Wheel/Tyre Guide ⇒ Rep. gr. 44 .
– Lower vehicle.
Note
After replacing brake pads, depress brake pedal firmly several
times with vehicle stationary so that the pads are properly seated
in their normal operating position.
– Check brake fluid level and top up if necessary.
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
5.5 Detaching and attaching front brake disc
(ceramic brakes)
WARNING
The brake disc rotor and the brake disc hub are bolted together
and must NOT be separated. DO NOT slacken the bolted con‐
nection on the brake disc hub.
– Raise vehicle.
– Remove wheels.
Caution
On vehicles with ceramic brakes the wheel must not be allowed
to drop onto the brake disc. This would cause irreparable dam‐
age to the disc. Screw two assembly pins (from vehicle tool kit)
into the wheel bolt holes when removing and fitting a wheel.
Insert the long assembly pin into the top hole.
– Detach brake caliper
100
Rep. gr.46 - Brakes - mechanism
⇒ page 90 .