Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
– Disconnect brake lines -1- and -2- from brake master cylinder
and hydraulic unit and remove.
– Unscrew securing bolts for brake master cylinder -1-.
– Carefully remove brake master cylinder from brake servo.
Installing
When installing, note the following points in particular:
♦ Before installing brake master cylinder, clean any residual
brake fluid off plenum chamber.
♦ When assembling brake master cylinder with brake servo unit,
make sure push rod is properly positioned in brake master
cylinder.
– Bleed brake system
164
Rep. gr.47 - Brakes - hydraulics
⇒ page 154
.