Removing And Installing Esp Sensor Unit G419 - Audi A6 2005 Workshop Manual

Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
– Pull brake light sensor out of its mounting -C-.
Installing
Note
The plunger adjusts itself automatically when the brake light
♦
sensor is inserted.
The brake pedal must remain in the normal position during
♦
installation and must not be depressed.
The brake pedal must be connected to the brake servo.
♦
– Fit brake light sensor in mounting -C- on brake pedal and press
in lightly -arrow A-.
Note
All three retaining tabs on the brake light sensor must engage
♦
audibly.
The sensor must not be rotated in the mounting on the brake
♦
pedal.
The plunger adjusts itself automatically when the brake light
♦
sensor is inserted.
– Turn coloured catch on brake light sensor all the way clock‐
wise -arrow B- to secure sensor.
– Plug in electrical connector.
– Install driver's storage compartment ⇒ Rep. gr. 68 .
After installing the brake light sensor, check the function of the
sensor before driving the vehicle.
6.3 Removing and installing ESP sensor
unit - G419-
The ESP sensor unit - G419- is located at the front of the centre
tunnel below the air conditioner.
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1410-
Removing
– Remove centre console extension ⇒ Rep. gr. 68
– Unplug electrical connector -1- from ESP sensor unit - G419- .
52
Rep. gr.45 - Anti-lock brake system