Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
2.6
Removing and installing engine speed
sender -G28-
Removing
– Remove rear noise insulation panel -2- ⇒ Rep. gr. 66 .
– Unplug electrical connector -2-.
– Unscrew bolt -1- and pull out engine speed sender -G28- .
Installing
Installation is carried out in the reverse order; note the following:
•
Tightening torque
⇒ „2.2 Ignition system - exploded view", page 52
– Install noise insulation ⇒ Rep. gr. 66 .
56
Rep. gr.28 - Ignition system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.