Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
– Fit the new seal in the brake caliper.
– Fit the new protective cap onto the brake piston as shown in
the illustration.
– Screw in compressor nut to dimension -a- 15 mm.
– Insert protective cap into groove in brake caliper. To do this
use removal wedge - 3409- .
– Carefully slide brake piston into brake caliper. Turn brake pis‐
ton as required. There are only four positions in which it is
possible to guide the brake piston over the compressor nut.
152
Rep. gr.47 - Brakes - hydraulics