– ... then press on housing retaining spring at the bottom and at
the same time press in pad retaining spring, as indicated by
-arrows-.
– Check that housing retaining spring is engaged correctly on
pad retaining spring and that top and bottom ends of housing
retaining spring are engaged correctly in brake carrier.
– Attach brake line
– Connect wear indicator connector and insert wire in dust cap
and protective cap.
– Fit wheels ⇒ Wheels and tyres; Rep. gr. 44 .
Note
The retaining spring must be pushed under the brake carrier
♦
after engaging onto both studs. If incorrectly installed, the wear
of the outer pad cannot be adjusted, and the pedal travel will
be increased as a result.
After installing the brake pads, depress the pedal firmly sev‐
♦
eral times with the vehicle stationary, so that the pads are
properly seated in their normal operating position.
– Check brake fluid level and top up if necessary.
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
2. Front brakes FNR G60 (PR 1LG/1LD/1LH/1LV/1ZL)
69