♦ Torque wrench - V.A.G 1410-
Removing
– Raise vehicle.
– Detach speed sensor wiring connector -1- from speed sensor.
– Remove bolt -2- from wheel bearing housing.
– Pull ABS speed sensor out of wheel bearing housing.
Installing
– Before inserting speed sensor, clean inner surface of fitting
hole and coat speed sensor thoroughly with lubricating paste
- G 000 650- .
– Insert speed sensor into drilling in wheel bearing housing and
tighten bolt to 18 Nm.
– Connect speed sensor to speed sensor wiring.
5.3
Removing and installing parts of ABS system on rear axle
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
5. Removing and installing parts of ABS system on front and rear axles
47