Renewing Front Brake Disc (Ceramic Brakes) - Audi A6 2005 Workshop Manual

Do not leave brake caliper and brake carrier hanging from brake
hose but secure them to bodywork using a suitable cable tie or
wire. Take care that brake hose is not damaged by weight of brake
components.
– Remove locating bolt -8- from brake disc, holding brake disc
in position.
– Take brake disc off wheel hub.
Note
Take care to keep the brake disc straight when taking it off the
wheel hub.
Installing
– Clean contact surfaces of wheel hub and brake disc and re‐
move corrosion.
– Fit brake disc onto wheel hub.
Note
Take care to keep the brake disc straight when fitting it onto the
wheel hub.
– Screw in locating bolt -8- and tighten to 10 Nm.
– Attach brake caliper
– Fit wheels.
Tightening torque for wheel bolts ⇒ Rep. gr. 44
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
5.6 Renewing front brake disc (ceramic
brakes)
WARNING
The brake disc rotor and the brake disc hub are bolted together
and must NOT be separated. DO NOT slacken the bolted con‐
nection on the brake disc hub.
⇒ page 90 .
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
101
5. Ceramic front brakes