Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
– Pull out pin -3-.
– Take out brake pedal.
Installing
Install in reverse sequence, paying attention to the following:
Attaching brake pedal to brake servo
– Hold ball head of push rod in front of mounting and push brake
pedal towards brake servo so that ball head audibly locks into
place.
– Install brake light switch
– Install brake light sensor
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
9.2
Separating brake pedal from brake ser‐
vo
Special tools and workshop equipment required
♦ Release tool - T10159-
– Remove driver's storage compartment. ⇒ Rep. gr. 68
– Remove brake light switch
– Remove brake light sensor
118
Rep. gr.46 - Brakes - mechanism
⇒ page 50
.
⇒ page 51
.
⇒ page 50
.
⇒ page 51
.