Audi A6 2005 Workshop Manual page 61

– Open plastic housing cover.
– Unplug electrical connector -1- on brake pressure sender.
– Detach brake pressure sender from pipe connector and un‐
screw.
Note
The brake line -2- only has to be disconnected in order to remove
the brake pipe connector.
Installing
– Installation is carried out in reverse sequence.
– Tightening torque: 28 Nm
The brake line -2- only has to be disconnected in order to remove
the brake pipe connector.
– After installing brake pipe connector, reconnect brake line
-2-. Tightening torque: 12 Nm
– Bleed brake system
⇒ Item 18 (page 33)
⇒ page 154 .
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
6. Removing and installing parts of ESP system
55