Installation; Additional Instructions - KEB COMBIVERT F6 Instructions For Use Manual

INSTALLATION

5 Installation
Attention

5.1 Additional instructions:

• The unit must be isolated from mains by main switch when working on parts under voltage.
• Mechanical brakes must be installed additionally if external forces have effect to the drive axis,
e.g. vertical axes (hanging loads) or rotary axes with asymmetrical weight distribution.
• For the protection against pollution (pollution degree 2) the installation of the units must be pro-
vided in environment with increased protection (e. g. control cabinet IP 54).
• Make sure that no small parts fall into the COMBIVERT during assembly and wiring. This also
applies to mechanical components, which can lose small parts during operation.
• Check the safety functions and error responses and generate an acceptance report after instal-
lation.
• The start-up can be prevented with interruption of the STO signals. STO may not be released in
case of danger according to EN 60204-1. Also note the instructions to the external safety switch
devices.
• Dimension the safety application by way that the corresponding input current of the safety func-
tions is available for the inputs (see chapter => 4.1). If several COMBIVERT or safety functions
are connected to one safety switchgear unit, this unit must be able to supply all COMBIVERT.
Danger
Warning
24
Before beginning
Before installation, read and note the EMC and safety instructions and
installation manual of the COMBIVIS.
Ensure coast of the motor
If danger to persons occur after switching off the motor control by STO,
the entrance to hazard areas must remain closed until the drive stops.
Selection of suitable voltage sources
Use for the connection only suitable voltage sources with safe isolation
(SELV / PELV) in accordance with VDE 0100 with nominal voltage of
24 Vdc ± 10%. Pay attention on a sufficient overvoltage category of the
voltage supply.