Table of Contents
Advertisement
GSM-204-423
Fitting
expansion
plates
To fit an expansion plate:
1.
2.
3.
Figure 3-12 shows an expansion plate, with cable pass-through ports indicated.
31st Oct 01
Remove and retain the eleven M6 anti-tamper Torx screws securing the
earth plate or blanking plate, (if fitted), and remove.
Fit the expansion plate and secure with previously retained Torx screws.
Tighten securing screws to the correct torque (see Site requirements and
considerations in Chapter 2 of this category).
To make the RF, dc power, fibre optic and signal connections between
multiple cabinets, (see Cable shroud installation procedures in Chapter
4 of this category).
RF PASS-THROUGH
FIVE CABLE GLAND
EARTH CABLE
PASS-THROUGH
AC CABLE
PASS-THROUGH
Figure 3-12 Expansion plate
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
BATTERY BACKUP CABLE
PASS-THROUGH
EXTENSION CABLE
RUBBER
PASS-THROUGH
GLAND HOUSING
Connecting antennas
FIBRE OPTIC
(not visible)
Inst. 3–35
Advertisement
Table of Contents
