Table of Contents
Advertisement
Unpacking and preparing the cabinet
Preparing the cabinet for lifting
To prepare the cabinet for lifting and remove it from the wooden delivery base:
1.
2.
3.
4.
5.
6.
7.
8.
Inst. 3–10
WARNING
The cabinet can weigh up to 360 kg. Handle with extreme
caution, and in accordance with local health and safety
regulations.
CAUTION
Care must be taken to avoid damaging the cabinet in any
way, especially by scratching the outer surfaces.
Carefully remove the cling wrap surrounding the cabinet.
Inspect the equipment immediately for damage. Report the extent of any
damage to the transport company.
nsert the eyebolts into the threaded lifting points on the cabinet sides,
I
ensuring that no cross-threading occurs.
WARNING
Before attempting to insert the eyebolts, visually check
each one for damage. If any damage is apparent, DO
NOT USE.
Do not overtighten the eyebolts; hand tight is sufficient. Do
not tighten eyebolts with a t-bar or spanner. Screw the
eyebolt fully into the lifting point so that no thread is left
exposed.
Attach lifting straps to the eyebolts and connect to lifting gear.
Open the cabinet doors and remove the TMS front cover (see Cabinet
access procedures this section) and the two rear mounting bolt cover
plates and store safely.
Refer to Figure 3-2 and remove the four nuts securing the cabinet to the
wooden delivery base.
Unscrew the securing bolts from underneath the wooden delivery base
until they are clear of the cabinet.
CAUTION
The cabinet may be subject to bending and distortion
during installation. To minimize this the TMS front cover
must be fitted and the cabinet doors must be closed,
before lifting the cabinet.
Refit the TMS front cover and close the cabinet doors.
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
GSM-204-423
31st Oct 01
Advertisement
Table of Contents
