Table of Contents
Advertisement
GSM-204-423
Radio and digital Power up with code load
To apply power radios and digital modules:
1.
2.
3.
4.
5.
6.
31st Oct 01
Turn each PSM switch to the OUTPUT ENABLE position. Check that each
PSM has the active (green) LED on and the alarm (red) LED off.
Press the CBM circuit breaker button marked SURF.
Press the CBM circuit breaker button marked BPSM A and (if a redundant
BPSM is fitted) BPSM B. Check all associated digital module LEDs
operate correctly; green LEDs lit on BPSM, NIU and MCUF, and red LEDs
off on NIU and MCUF.
MCUF initialization will commence at power up. A connection to the BSC
will be established and code download will take place. After completion of
the download, the site will be initialized.
NOTE
Both red and green LEDs are initially lit on the NIU while
the unit performs a self-test. The red LED will extinguish
after approximately 50 seconds when rebooting after a
code download.
CAUTION
If the code is a different version, the non-volatile memory
will be upgraded at this point. Both LEDs will be flashing,
and a warning message will appear on the PC terminal.
Do not power down or reset the cabinet as this will corrupt
the non-volatile memory. If this happens, contact Motorola
Customer Network Resolution Centre and request the
boot code restoration procedure and the appropriate boot
code file.
Press the CBM circuit breaker buttons for the appropriate CTUs fitted, and
check that the RADIO STATUS LED for each CTU flashes green.
At this point, after the MCUF has initialized, the CTUs will download code
from the MCUF.
CAUTION
If the code is a different version, the non-volatile memory
will be upgraded at this point. Both LEDs will be flashing.
Do not power down or reset the cabinet as this will corrupt
the non-volatile memory. If this happens, contact Motorola
Customer Network Resolution Centre and request the
boot code restoration procedure and the appropriate boot
code file.
Once fully initialized, the RADIO STATUS LED on the front of each CTU
should be green, and each TRANSMIT STATUS LED should be either off
or yellow.
Disconnect the 9 to 9-way cable from the MCUF TTY port.
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
Powering up the cabinet
Inst. 7–13
Advertisement
Table of Contents
