Table of Contents
Advertisement
GSM-204-423
TMS front cover removal and refitting
To remove the TMS front cover:
1.
2.
3.
To refit the TMS front cover:
1.
2.
3.
Procedures for
unpacking and
preparing the
cabinet
The following describes the procedure for unpacking the equipment.
Dismantling the shipping packaging and obtaining template
To dismantle the shipping packaging and obtain template:
1.
2.
3.
4.
5.
6.
7.
The cabinet is now ready to be prepared for lifting.
31st Oct 01
NOTE
The TMS front cover can only be removed and refitted
when both doors are open.
Remove and retain the four push in plastic covers.
Using a cross point screwdriver, undo the four captive fasteners by turning
anticlockwise until they release.
Lift the TMS front cover away from the cabinet and store safely.
Refit the TMS front cover and line up the four fasteners.
Using a cross point screw driver, tighten the four captive fasteners.
Refit the four push in plastic covers.
NOTE
It is recommended that the installer reads through the
following procedure before starting to unpack and install
the equipment.
Cut the plastic banding that secures the packaging.
Lift the lid free of the box.
Remove separate template from the inside of the box lid, and deliver to
the site for site preparation.
Remove the wooden spreader and the blanks and accessory trays from
the box.
Undo the taped fastening on the box side.
Unwrap the box from around the cabinet, (the wrap-around box is secured
by velcro).
Unbolt the two wooden packing pieces from the lifting points in the cabinet
sides.
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
Unpacking and preparing the cabinet
Inst. 3–9
Advertisement
Table of Contents
