Table of Contents
Advertisement
Connecting antennas
Fitting left side
(cable entry)
earth plate
To fit the left side (cable entry) earth plate:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Inst. 3–34
Remove and retain the eleven M6 anti-tamper Torx screws securing the
left side blanking plate, (if fitted). Remove the blanking plate.
Fit left side (cable entry) earth plate and secure with previously retained
Torx screws. Tighten securing screws to the correct torque (see Site
requirements and considerations in Chapter 2 of this category).
Connect the short earth cable to the left side cabinet earth stud and
tighten to the correct torque.
Route RF cables and long earth cable from left side earth plate through
top section cable guides, indicated in Figure 3-10.
Remove the earth cable from the interface panel earth stud and fit long
earth cable from left side earth plate. Tighten to correct torque (see Site
requirements and considerations in Chapter 2 of this category).
CAUTION
Incorrect connection of RF cables could result in network
planning and optimization difficulties, care must be taken
to ensure that the correct RF configuration for the site is
maintained.
Note the identification of the existing connections between the right earth
plate and RF components. Disconnect each cable from the SURF module
or Tx block, one at a time, and connect corresponding RF cable from left
side earth plate, until all RF cables, appropriate for the desired RF
configuration, are connected.
Disconnect the short earth cable from the right side cabinet earth stud.
Remove and retain the eleven M6 anti-tamper Torx screws securing the
right side earth plate. Remove the right side earth plate, complete with
cables.
Fit right side blanking plate and secure using with previously retained Torx
screws. Tighten securing screws to the correct torque (see Site
requirements and considerations in Chapter 2 of this category).
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
GSM-204-423
31st Oct 01
Advertisement
Table of Contents
