Table of Contents
Advertisement
Suggested RF configurations
Configuration
for sector 1/1 or
2/2
Figure 3-19 shows a suggested configuration, using a single Horizon macro
cabinet, for sector 1/1 or 2/2 with duplexed combining bandpass filter.
Unused SMA connectors must be fitted with 50 ohm terminating loads as shown
below.
Configuration
for sector 1/1
Figure 3-20 shows a suggested configuration, using one Horizon macro cabinet,
for sector 1/1 with twin duplexed filter.
Inst. 3–44
Figure 3-19 Single cabinet sector 1/1 or 2/2 with DCF
If configured for...
sector 1/1
Figure 3-20 Single cabinet sector 1/1 with TDF
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
Then 50 ohm load required on
unused SMA input to...
DCF 0 and DCF 2
GSM-204-423
31st Oct 01
Advertisement
Table of Contents
