Table of Contents
Advertisement
GSM-204-423
General warnings
Introduction
Observe the following warnings during all phases of operation, installation and
maintenance of the equipment described in the Motorola manuals. Failure to
comply with these warnings, or with specific warnings elsewhere in the Motorola
manuals, violates safety standards of design, manufacture and intended use of
the equipment. Motorola assumes no liability for the customer's failure to comply
with these requirements.
Warning labels
Personnel working with or operating Motorola equipment must comply with any
warning labels fitted to the equipment. Warning labels must not be removed,
painted over or obscured in any way.
Specific
warnings
Warnings particularly applicable to the equipment are positioned on the
equipment and within the text of this manual. These must be observed by all
personnel at all times when working with the equipment, as must any other
warnings given in text, on the illustrations and on the equipment.
High voltage
Certain Motorola equipment operates from a dangerous high voltage of 230 V
ac single phase or 415 V ac three phase supply which is potentially lethal.
Therefore, the areas where the ac supply power is present must not be
approached until the warnings and cautions in the text and on the equipment
have been complied with.
To achieve isolation of the equipment from the ac supply, the ac input isolator
must be set to off and locked.
Within the United Kingdom (UK) regard must be paid to the requirements of the
Electricity at Work Regulations 1989. There may also be specific country
legislation which need to be complied with, depending on where the equipment
is used.
RF radiation
High RF potentials and electromagnetic fields are present in the base station
equipment when in operation. Ensure that all transmitters are switched off when
any antenna connections have to be changed. Do not key transmitters
connected to unterminated cavities or feeders.
Refer to the following standards:
S
S
31st Oct 01
ANSI IEEE C95.1-1991, IEEE Standard for Safety Levels with Respect to
Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to
300 GHz .
CENELEC 95 ENV 50166-2, Human Exposure to Electromagnetic Fields
High Frequency (10 kHz to 300 GHz) .
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
General warnings
7
Advertisement
Table of Contents
