Table of Contents
Advertisement
GSM-204-423
Fitting the outdoor cabinet onto its base
Procedure for
fitting a BTS
cabinet
To fit a Horizon macro outdoor BTS cabinet onto a prepared concrete base, (or
steel structure):
1.
2.
3.
4.
5.
6.
7.
Mounting
additional
cabinets
At this stage, additional Horizon macro outdoor BTS cabinets, optional cable
shrouds and/or optional auxiliary equipment housings may be installed,
depending on the site configuration (see Site requirements and
considerations). Refer to Chapters 2, 4 and 5 in this category for information
on installing, multiple cabinet layouts, cable shrouds and auxiliary equipment
housings.
31st Oct 01
An equipped Horizon macro BTS cabinet can weigh up to
WARNING
360 kg.
Observe proper lifting precautions and handle each
cabinet with extreme caution to avoid tipping.
Place the Horizon macro outdoor BTS cabinet onto the template, (or steel
structure).
Open the cabinet doors and remove the TMS front cover see Unpacking
and preparing the cabinet (cabinet access procedures).
Line up the fixing holes in the bottom of the cabinet with the previously
installed anchors, (or holes in steel structure).
Place a flat washer onto each M12 mounting bolt and fit the four mounting
bolts loosely. Do not tighten yet.
Use a spirit level to verify that the cabinet is level. If necessary, use shims
to level the cabinet. Tighten up the mounting bolts to the correct torque,
(the setting of torque value for M12 anchor screws/bolts depends on local
supplies. Refer to the manufacturer's data for correct values).
Refit the bottom front panel and the two rear mounting bolt cover plates,
previously retained.
Remove each of the eyebolts from their threaded holes (located on the
sides of the cabinet), and return the eyebolts to the tool kit for future use.
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
Fitting the outdoor cabinet onto its base
Inst. 3–15
Advertisement
Table of Contents
