Table of Contents
Advertisement
GSM-204-423
Routeing RF
cables between
cabinets.
When routeing RF cables between cabinets in Motorola supplied configurations:
1.
2.
3.
Refer to Cable shroud installation procedures (Installation between cabinets
and Cable routeing for multiple cabinet sites) in Chapter 4 of this category for
full details of RF gland refitting and shroud installation.
Types of RF
connector
Table 3-2 list the RF module connectors with their destinations.
Torque of RF
connectors
For correct torque of connectors, see Installation & Configuration: GSM-204-423
Chapter 2 Site requirements and considerations.
31st Oct 01
Remove the expansion plate pass through blanks, as required.
Undo the two hose clips securing each RF cable gland housing and
remove gland assembly.
Feed any RF cables through the expansion plates.
Table 3-2 RF module connectors and destinations
RF module
CTU transceiver
Tx block
SURF
Earth/connector plate
CAUTION
Care should be taken when tightening SMA connectors to
avoid damage by excessive force.
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
Type of connector
SMA
SMA
N-type
7/16
N-type
7/16
Connecting antennas
Destination
Tx block (underneath)
CTU transceiver
SURF
Earth/connector plate
Rx N-type of Tx Block
Antenna or
additional cabinets
Inst. 3–33
Advertisement
Table of Contents
